Luxe X pods | test protocol for the 40 W Vaporesso kit

Three LEDs for a display, 40 W of output and three pods rated at 32, 21 and 16 W. The Vaporesso Luxe X never shows what it sends into the coil, and the Luxe X pods carry no reading of their own either. For a test bench, that silence raises a real question. Without a screen, the claimed wattage cannot be read anywhere, and the only way to check it is to turn it into quantities that can be measured, then record them at the battery output.

Luxe X pods, what the grid measures and what it only records

The Luxe X is a Vaporesso pod kit with a built-in 1500 mAh battery, rated at 40 W maximum, that takes bottom-fill Luxe X pods with a built-in coil. The bench measures four things on it, the voltage delivered to each pod, the Type-C charging time, the real capacity of the pod received and the draw difference between the two ways the pod can sit. COREX technology, the claimed leak resistance and pod lifespan stay as claims, recorded without being scored.

That split rests on a simple constraint. A figure the manufacturer publishes and the device does not display becomes a hypothesis to check, not a result.

The Luxe X spec sheet used before the bench

Vaporesso’s official kit page is the starting point. The values below are the ones the grid later holds against its readings.

Feature	Claimed value	Status on the bench
Battery	1500 mAh, built in	Observed through charging time
Output	40 W	Measured as voltage
Charging	Type-C, 5 V and 1.5 A	Measured
Display	3 LEDs	Observed
0.4 ohm mesh pod	32 W	Measured as voltage
0.6 ohm mesh pod	21 W, not in the kit	Measured as voltage
0.8 ohm mesh pod	16 W	Measured as voltage
Capacity	5 ml, or 2 ml in the TPD version	Measured
Management	AXON chip that recognises the coil	Claimed

The same page lists an auto-lock, a secured mode against accidental firing and a PCTG tank. These are noted on arrival but play no part in the score.

The name covers several devices, though. Vaporesso’s own page for the pods lists the Luxe X2 (2000 mAh, 0 to 40 W), the X3 (2600 mAh, 5 to 45 W) and the 80 W XR Max and XR Max 2 as compatible, without naming the original Luxe X. On that first kit, the grid therefore tests only the three values on its own page, 0.4, 0.6 and 0.8 ohm.

Voltage and current of Luxe X pods

With no screen, wattage can only be checked through voltage and current. The calculation starts from the published values, then the bench holds the result against a reading under load.

Three wattages that land on the same voltage

Voltage follows from wattage and resistance as V = √(P × R), and current as I = √(P / R), the same calculation applied to the Geekvape Soul 2 and its cartridges. Run on the three pods in the spec sheet, it gives a clear result.

Pod	Claimed wattage	Calculated voltage	Current through the coil
0.4 ohm mesh	32 W	3.58 V	8.94 A
0.6 ohm mesh	21 W	3.55 V	5.92 A
0.8 ohm mesh	16 W	3.58 V	4.47 A
0.4 ohm at the ceiling	40 W	4.00 V	10.00 A

All three published wattages correspond to a voltage close to 3.6 V, 0.03 V apart at most. The Luxe X therefore behaves as if it applied a roughly fixed voltage, with the wattage then following from the resistance of the pod fitted. The 40 W ceiling appears on none of the three pods, since it would need 4.00 V across the 0.4 ohm coil.

What the bench records at the output

That calculation remains a reading of published figures, not a measurement. The bench places a measuring adapter between the battery and the pod, records the voltage during the draw, then measures the pod’s cold resistance to work out the real wattage.

The reading is repeated with a full battery, then with two LEDs and with a single LED lit. A voltage that drops as the charge falls reveals an output that weakens over time, which the kit’s LEDs never show.

Luxe X battery and Type-C charging, a time to measure

Vaporesso’s Luxe X page gives Type-C charging at 5 V and 1.5 A but publishes no charging time. The bench times it itself, with the battery run down to cut-off and a USB tester placed between the charger and the cable.

This tester records the current the kit actually draws, which may stay below the 1.5 A claimed, and the energy taken in until charging stops. It follows the method of our measurement of a battery charger’s real current, applied here to a built-in cell.

The 1500 mAh figure cannot be checked directly on a soldered battery. The grid only records how many fixed-length activations come between a full charge and cut-off, on a single pod, to compare the Luxe X with the other pod kits on the bench.

Turning the pod round, two draws to tell apart

On the original Luxe X, airflow has no adjustment ring. According to Vaporesso, the pod sits one way or the other to switch from a loose draw to a tight one, presented as two modes, one for big clouds and one for small clouds.

The bench measures the gap between the two positions at a constant airflow, with a pressure gauge connected to the mouthpiece. The suction recorded in each position puts a number on what the spec sheet describes in two words. Voltage is recorded both ways too, to confirm that turning the pod changes the air and not the output.

Newer models in the range drop this approach. The Luxe X Pro page claims adjustable airflow and wattage with a 0.42 inch OLED screen, two points that change the test grid.

Luxe X pods capacity, 5 ml claimed and the 2 ml UK cap

The original kit is listed with 5 ml pods in its standard version. In the UK, refillable tanks and pods are limited to 2 ml, and Vaporesso makes the Luxe X kit in a TPD version supplied with two 2 ml pods. Nicotine e-liquid sold in the UK is also capped at 20 mg/ml in bottles of up to 10 ml.

To check the version received, the empty pod is weighed, filled with demineralised water from the bottom up to the mark, then weighed again, one gram being roughly one millilitre at room temperature. Three pods of each value go on the scales, to tell a moulding difference from a genuine version change.

COREX and COREX 2.0, what changes on Luxe X pods

Vaporesso credits the performance of its Luxe X pods to its COREX heating technology. A newer generation now sells as COREX 2.0, and two UK retailers describe it in matching terms.

A narrower mouthpiece, checkable with callipers

According to those two retailers, the Luxe X COREX 2.0 pods pair a so-called morph mesh with COREX cotton, come in packs of two and get a narrower mouthpiece designed for a tighter draw. One of them specifies that only the 0.6 and 0.8 ohm pods take the slimmer mouthpiece, while the 0.3 and 0.4 ohm pods keep the original wide one.

That change of shape can be measured. The grid records the mouthpiece width of each generation with callipers, then the suction at a constant airflow, to find out whether the new mouthpiece changes the draw as much as turning the pod round.

A claimed lifespan, recorded without a score

Both retailers also credit the COREX 2.0 generation with a longer lifespan, without a shared figure. The lifespan of a built-in coil depends on the e-liquid, the wattage and the user’s pace, so the bench does not score it. It only records the cold resistance before and after a fixed series of activations, to flag any drift.

Scoring grid for the Luxe X and protocol limits

Weightings are set before the kit reaches the bench, so that the Luxe X stays comparable with the other pod kits tested and its two pod generations stay comparable with each other.

Criterion	Weight	Status
Delivered voltage against claimed wattage, per pod	25%	Measured
Voltage stability across the charge level	20%	Measured
Type-C charging time and current	15%	Measured
Real capacity of the pod received	15%	Measured
Draw difference between the two positions	10%	Measured
Mouthpiece and draw of COREX 2.0 pods	10%	Measured
Claimed pod lifespan	5%	Claimed

Each series runs with new pods, the same 50/50 e-liquid and the same room temperature. The bench never tests a pod outside the wattage its spec sheet assigns to it.

FAQ

These questions fall outside the protocol, but they come up as soon as a Luxe X reaches the bench.

What is the difference between the Luxe X and the Luxe XR?

The pod. Vaporesso gives both kits the same 1500 mAh battery, 40 W, three LEDs and Type-C charging. The Luxe XR ships with two empty pods, one DTL and one MTL, into which GTX coils of 0.4 and 0.8 ohm clip, whereas the Luxe X takes pods with a built-in coil.

What comes in the Luxe X kit?

According to the manufacturer, the box holds the battery, two mesh pods of 0.4 and 0.8 ohm, a Type-C cable, a user manual and a warranty card. The TPD version has the same contents with 2 ml pods instead of 5 ml.

Do COREX 2.0 pods fit the original Luxe X?

Yes. The compatibility lists published alongside these pods overlap on the Luxe X, Luxe X Pro, Luxe X2 and Luxe XR Max, with one of them adding the Luxe XR, XR Max 2 and X3.

What does the AXON chip in the Luxe X do?

Vaporesso describes it as a control chip that recognises the resistance of the pod fitted, under the name Smart Control. It is what pairs each pod with the wattage on its spec sheet, which the voltage reading is designed to check.

How do you stop a Luxe X firing in a pocket?

The manufacturer describes an auto-lock and a secured mode intended to prevent accidental firing. The exact steps are in the user manual supplied with the kit, to be checked against the version received.

What the bench keeps from Luxe X pods

On the Luxe X, the spec sheet publishes three wattages but implies a single voltage, close to 3.6 V. The bench checks that reading at the battery output, at several charge levels, then measures what the spec sheet leaves out, the charging time, the capacity of the version received and the draw gap from one position to the other.

The pod generation, COREX or COREX 2.0, is recorded before any comparison, and that record is what makes Luxe X pods comparable with the other pods run on this bench.

Editorial content for adult readers only. Vaping products can contain nicotine, which is a highly addictive substance. Vaping products are not for sale to anyone under 18 in the UK. This article is not a buying recommendation.